Decorative protective sealer for cementitious finishes
(formally Known as Vetotop AC444)
Vetotouch Sealer is an environmentally friendly polymeric pore sealer for Vetotouch range of decorative products. The product seals the surface finish to protect against contaminants and water ingress.
Vetotouch Sealer is supplied in 20 liters pail. Theoretical coverage: 3 - 6 m2/ liter/ coat
Original sealed containers of Vetotouch Sealer has a shelf life of 12 months provided it is stored clear of ground in a dry and shaded place below 35ºC.
Designed to work with Vetotouch range of cementitious decorative products. The application is designed to a 2 - 3 coats at a rate of 3 to 6 m2 per liter per coat to achieve best results and closing the substrate surface. The coverage rate may decrease or increase depending on the porosity of the substrate and its texture.
Note: You can dilute by water up to 15% if required.
Vetotouch Sealer should be applied as a continuous flood coat using either a soft brush or low pressure spray equipment at the correct coverage rate. For best performance apply a flood of 2 - 3 coats at rate 3 - 6 m2 per liter per coat
Equipment and tools can be cleaned using clean water immediately after use. Shall residual material exist or harden, mechanical means such as wire brush would be required to remove residue.
Surface must be sound and thoroughly cleaned by compressed air before Vetotouch Sealer is applied.
Vetotouch Sealer should not come into contact with skin and eyes or be swallowed. Avoid inhalation of vapor and spray. Use only in well ventilated areas. In case of insufficient ventilation wear suitable respiratory protection.
Wear suitable protective clothing, gloves and eye/face protection. Barrier creams provide additional skin protection.
Should accidental skin contact occur, remove immediately with a suitable skin cleanser followed by washing with soap and water.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
If swallowed, seek medical attention immediately - do not induce vomiting.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Multipurpose low viscosity bonding agent & admixture
High Quality Monofilament Polypropylene Fibers
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Slightly Elastic Solvent free Industrial-Grade high performance, high build epoxy flooring system