Corrosion inhibitor for steel reinforcement accepting cementitious repair or concrete
Vetoprime CP437 is a two component polymer modified cementitious primer designed to enhance the bond between the Concrete Repair range of repair mortars and existing reinforced steel. Vetoprime CP437 is also designed to protect the steel reinforcement by providing a highly alkaline passivating layer around the reinforcement and by the use of migrating corrosion inhibitor technology, which minimises further corrosion to surrounding steel reinforcement.
Vetoprime CP437 is supplied in 2 kg Kit & 4 kg Kit, with Coverage: 1.2m2 @ 1mm
Original sealed container of Vetoprime CP437 has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Mix Vetoprime CP437 by slowly adding the powder component to the liquid component and mix thoroughly for about 2 minutes until a smooth, even consistency is obtained.
As Reinforcement Primer
Apply by brush two coats of approximately 1mm thickness, allowing each coat to reach initial set prior to application of the second coat.
All tools and equipment shall be cleaned immediately after use with water.
It is essential that Vetoprime CP436 is applied to a sound, clean and dry surface in order to achieve maximum bond strength between substrate and coating/repair products.
All rust and scale should be removed from any exposed steel reinforcement by grit blasting techniques or equivalent approved methods to a bright steel condition
At temperatures below 20ºC, the cure rate will be slower. Conversely, at temperatures above 20ºC, the cure rate will be faster.
Vetoprime CP437 should not come into contact with skin and eyes or be swallowed. Avoid inhalation of vapor and spray. Use only in well ventilated areas. In case of insufficient ventilation wear suitable respiratory protection. Wear suitable protective clothing, gloves and eye/face protection. Barrier creams provide additional skin protection. Should accidental skin contact occur, remove immediately with a suitable skin cleanser followed by washing with soap and water. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. If swallowed, seek medical attention immediately - do not induce vomiting.
Vetoprime CP437 is non-flammable.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Multipurpose low viscosity bonding agent & admixture
High Quality Monofilament Polypropylene Fibers
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Two-component polysulphide trafficable joint sealant
(Formerly known as Saveto PS2)