Abrasion resistant flexible epoxy based transition mortar
Vetorep ER450 is a three component system consisting of solvent free epoxy resins together with a special blend of fillers to provide a flexible trowel grade epoxy mortar. The mixed mortar is designed for use in bridge and highway transitioning joints and between concrete, asphalt and steel.
Vetorep ER450 is supplied in 25 Kg kits with a yield of 12 Liters / Kit
Original sealed kits of Vetorep ER450 has a shelf life of 12 months provided it is stored clear of ground in a dry and shaded temperature controlled place <25ºC.
Vetorep ER450 should be applied by first tamping, followed by trowelling using steel float.
Vetorep ER450 should be removed from tools, equipment and mixers with Vetonit Solvent XX immediately after use.
Vetorep ER450 should be allowed to cure for 24 hours at 25°C before being subjected to foot traffic. At the same temperature, full mechanical and chemical properties are achieved after 7 days (please consult Saveto Technical Department for details of curing times at other temperatures).
The surface must be structurally sound, free from oil, grease and other forms of contamination. Concrete should be surface dry and suitably prepared either by scabbling or grit blasting to remove any surface
Vetorep ER450 comprises of three components, a resin base, hardener and filler which are pre-weighed to the correct proportions. Under no circumstances should part mixing be carried out.
Ensure that the bottom and sides of resin containers are thoroughly scraped; transfer the entire contents of the hardener container into the base container. Using a mixing paddle attached to a heavy duty slow speed electric drill, mix for approximately 2 minutes until a uniform consistency is obtained.
The resin mixture should then be transferred to a separate container or forced action pan mixer, and the FILLER gradually added and mixed for a further 2 minutes or until the filler has thoroughly wetted out and a uniform consistency is obtained.
Vetorep ER450 contains epoxy resin and coal tar which may cause skin sensitisation in certain individuals. Skin contact should be avoided and a suitable barrier cream applied or disposable rubber or plastic gloves worn. Also use eye/face protection. If contact with skin occurs, it must be removed before it hardens followed by washing with soap and water. In case of contact with eyes rinse immediately with plenty of water and seek medical treatment immediately.
Vetorep ER450 is flammable. Do not smoke during use. Do not use near a naked flame.
Flash point: 35ºC
For further information, refer to the Product Material Safety Data Sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Epoxy resin twin cartridge anchoring grout
Polyester injection and anchoring grout
Water based concrete curing compound
Resinous, render receiving concrete curing compound
Water based acrylic curing compound and primer
Dual component cementitious coating and color nuetralizer for cementitious decorative finishes