Cementitious polymer modified decorative finish coat applied at thicknesses from 1 to 5 mm
Vetotouch Europa is a cement based decorative finish composed of hydraulic binders, selected aggregates and special additives . It is supplied as a dry powder in a pre-weighed bags ready to use on site, which requires only addition of clean water to produce easily workable mortar.
Vetotouch Europa supplied in 25 Kg Bag
Coverage - 1.0 - 1.2 Kg /m2 / mm Thickness
Original sealed bags of Vetotouch Europa has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Add to the mixing container 7.5-8.5 liters of water for each 25 kg bag of Vetotouch Europa. Add the powder to the water and mix with a mechanical plaster mixer or low speed heavy duty electric drill fitted with a suitable paddle for 3-4 minutes, until a uniform, lump free consistency is achieved. Leave the mixed material to stand for 10 min and briefly remix without addition of water.
Manual mixing is allowed for small batch quantities and mix for approx. 1-2 min or when homogeneous mix is achieved.
Where manual application is made (not by spray machines), you can optionally add 0.5 to 1.0 liter of Vetobond AB432 to the mixing water and adjust the water requirement accordingly for each 25 kg adjust the water requirement accordingly for each 25 kg bag. Follow same mixing procedure as described above.
Mixed material must be used within 30-60 minutes.
Do not add water, once the mixed mortar start to harden.
Vetotouch Europa can be applied in a single or multiple coats on smooth (plastered) surfaces by trowel application to achieve desired thickness 1-5 mm.
Vetotouch Europa is best cured by spraying an acrylic based curing compound on the surfaces of applied materials. Manual curing can be used, however it is critical that water is sprayed uniformly on the surface keeping it moist at all times for a period of 3 days
Vetotouch Europa is highly alkaline therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. Any skin contact should be wash with soap & water. In case of eyes irritation, immediately wash with copious amount of clean cold water. Seek medical advise.
Vetotouch Europa is non-flammable.
For further information, please refer to material safety data sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Advanced Modified Cementitious Thermal Insulating Plaster
Premixed cementitious masonry grout
Adhesive for autoclaved aerated concrete block
Premixed cementitious masonry mortar
Cementitious based adhesive and base coat for EIFS / ETICS
Cementitious tile adhesive for fixing marble & mosaic tiles.
Exterior decorative textured render
Grooved decorative finish coat
Marble chip decorative exterior and interior finishing system